 |
More detailed power
quality analysis capability, and a new Fluke-patented energy
monetization function
The new 430 Series
II Power Quality and Energy Analyzers offer the best in power
quality analysis and introduce, for the first time ever, the
ability to monetarily quantify energy losses.
The new Fluke 434,
435 and 437 Series II models help locate, predict, prevent, and
troubleshoot power quality problems in three-phase power
distribution systems.
Additionally, the
Fluke-patented energy loss algorithm, Unified Power Measurement,
measures and quantifies energy losses due to harmonics and
unbalance issues, allowing the user to pinpoint the origin of
energy waste within a system |
Overview
- Energy Loss Calculator: Classic active and reactive
power measurements, unbalance and harmonic power, are quantified
to pinpoint true system energy losses in dollars (other local
currencies available).
- Power Inverter Efficiency: Simultaneously measure AC
output power and DC input power for power electronics systems
using optional DC clamp.
- PowerWave Data Capture: 435
and 437 Series II analyzers
capture fast RMS data, show half-cycle and waveforms to
characterize electrical system dynamics (generator start-ups,
UPS switching etc.).
- Waveform Capture: 435
and 437 Series II models
capture 100/120 cycles (50/60Hz) of each event that is detected
in all modes, without set-up.
- Automatic Transient Mode:
435 and 437
Series II analyzers capture 200kHz waveform data on all phases
simultaneously up to 6kV.
- Fully Class-A Compliant: 435
and 437 Series II analyzers
conduct tests according to the stringent international IEC
61000-4-30 Class-A standard.
- Mains Signaling: 435
and 437 Series II analyzers
measure interference from ripple control signals at specific
frequencies.
- 400Hz Measurement: 437
Series II analyzer captures power quality measurements for
avionic and military power systems.
- Troubleshoot Real-Time: Analyze the trends using the
cursors and zoom tools.
- Highest Safety Rating in the Industry: 600V CAT IV,
1000V CAT III rated for use at the service entrance.
- Measure All Three Phases and Neutral: With the
included four flexible current probes with enhanced thin flex
designed to fit into the tightest places.
- Automatic Trending: Every measurement is always
automatically recorded, without any set-up.
- System-Monitor: Ten power quality parameters on one
screen according to EN 50160 power quality standard.
- Logger Function: Configure for any test condition
with memory for up to 600 parameters at user defined intervals.
- View Graphs and Generate Reports: With included
analysis software.
- Battery Life: Seven hours operating time per charge
on Li-ion battery pack.
|
