|
|
|
Model CR50 Capacitance and Resistance Meter
Sort, Match, QC inspect, and verify components, check circuits with
this full range capacitance and resistance meter.
- Dual Zero adjustment pots to Null strays and Test Leads.
- Special "Low Ohms" Range.
- Oversized, read-at-a-glance Display.
- Premium Test Leads with alligator clips.
- Resistance: 0.01Ω to 20MΩ, ±0.5%.
- Capacitance: 0.1pF to 20mF, ±0.5%.
- Diode and Continuity Test.
CR50 Datasheet PDF
(109kb) |
|
|
|
|
|
|
|
|
Model LCR55 Component
Checker
The ultimate component checker measures Inductance, Capacitance, Resistance, Transistors, Diodes
and Microwave Diodes.
- Plug-in test slots and test leads.
- Oversized, read-at-a-glance Display.
- Data Hold and Max Hold.
- Auto-off.
- Resistance: 0.01Ω to 20MΩ, ±0.5%.
- Capacitance: 0.1pF to 2000μF, ±1.0%.
- Inductance: 0.1μH to 200H, ±0.5%.
- Transistors: Hfe, Iceo (NPN, PNP).
- Diodes: Standard (3V) and Microwave oven (8V).
- Continuity Test.
LCR55
Datasheet PDF (127kb) |
|
|
|
|
|
|
|
|
Model SF10 Short Finder
- Fastest method of finding shorts and continuity on PCBs.
- Brush probe quickly pinpoints area of shorts in printed circuit
cards, multi-conductor cables, mass termination systems, backplanes,
connectors, IC sockets and more.
- Low-test voltage protects sensitive circuitry and eliminates false
continuity indications.
- Patented circuitry saves time with rapid testing for shorts.
- Output Voltage: 0.5V DC.
- Maximum Current: 100μA.
- Continuity Threshold: 10 ohms.
- Brush Material: Stainless Steel.
- Dimensions: 213.2mm (L) x 33.7mm (W) x 25.2mm (H)
8.4" (L) x 1.3" (W) x 1" (H).
SF10 Datasheet
PDF (93kb) |
|
Short Finder
Finding shorts in complex
printed circuit boards is a tedious and time-consuming process. Designed
for use in electronics manufacturing, the Short Finder Brush allows
electronics manufacturing and service/repair personnel to quickly sweep
over multiple test points to instantaneously find the approximate location
of continuity.
The unique brush probe design saves time by eliminating
the need to check each test point individually.
The Short Finder is used by holding the reference probe
in contact with the point of test then sweeping the PCB with the brush
until continuity is identified by an audible tone. The exact point of
continuity can be identified by using the ridged probe tip to conduct a
point-to-point search within the area previously identified by the brush. |
|
